Incubator use methods are as follows

Incubator use methods are as follows:
1, pay attention to the use of equipment must be installed before the leakage protector, check whether the power supply voltage used is qualified (using voltage 220V), if the voltage is unstable, need to be equipped with a voltage regulator.
2, check the equipment: before using the equipment to do a comprehensive inspection, check whether the components are normal.
3、Environmental requirements: the incubator working environment requires good ventilation (incubator can not be placed directly in front of the vent), the work needs to be placed smoothly, the bottom to prevent moisture.
4, boot: switch on the order of: the general switch (regulator), power switch, fan switch, heating switch, humidification switch. Lighting switch can be turned on and off as needed.
5、Check the operation: after starting the machine, observe whether the fan and egg turning work normally, whether the angle of egg turning is appropriate, and whether the control situation is good.
6, into the hatching conditions: 3 hours after the start (3 hours after the start, the actual temperature and humidity within the incubator is not stable is a normal phenomenon), check out the actual temperature and humidity within the incubator and the set temperature and humidity is consistent, since the actual temperature and humidity of the incubator to reach the set value to start calculating, to be 5 hours after the temperature and humidity is still maintained within the range, you can place the eggs incubation.
7, put and take the seed eggs: put and take the seed eggs, manually turn over the eggs (press and hold the "increase" key for 2 seconds after the controller into the manual turn over the eggs state) so that the egg frame to keep horizontal, cut off the power supply of the incubator, you can put and take the seed eggs; finished opening the power supply, manually turn over the eggs so that the egg frame running to the set angle, return to the working state. The rotation direction of the egg rack is automatically selected by the controller.
8、Cancel the alarm: the incubator does not work for a long time, when the machine is turned on, due to the temperature or humidity and set the temperature or humidity is not consistent with the alarm phenomenon, press the "Reduce" key to stop the alarm.